|
|
 |
|
 Input Voltage: |
90~264VAC |
 |
Input Frequency: |
47~63Hz |
|
Inrush Current: |
The maximum inrush current will not exceed 30A at 115VAC or 60A at 230VAC input, cold start, 25°C |
|
Load Range: |
At factory, all outputs at 60% rated load condition; the +5V output is set to between 4.9~5.1V. The other outputs are checked to be within the specified voltage accuracy range. |
|
Ripple and Noise: |
The peak to peak ripple and noise for each output is less than 1% of each output voltage at rated load, 115/230VAC. Measuring is done by 15MHz bandwidth limited oscilloscope and terminated each output with a 47μF capacitor |
|
Line Regulation: |
The line regulation for +12V is less than +/-2%, for other output is less than +/-1% while measuring at rated load and +/-10% of nominal line input voltage changing |
|
Load Regulation: |
The output voltage load regulation is less than the values in the following table by changing each output loading +/-40% from 60% rated load, and keep all other outputs at 60% rated load |
|
Hold Up Time: |
Hold up time is 14ms typical by measuring from the last AC line charging pulse to the point that +5V drop down to +4.75V at rated load |
|
Output Power: |
The total DC continuous power shall be kept within 200W |
|
Power Good Signal: |
When power start up, the power good signal will increase 100ms to 500ms after all output DC voltages are within regulation limits |
|
Power Fail Signal: |
The power fail signal will fall at least 1ms before any of the output voltages lower than the regulation limits |
|
Efficiency: |
The efficiency is 65% typical by measuring at nominal line, and full rated load |
|
Protection: |
For some reason the power supply fails to control itself, the build-in over voltage protection circuit will shut down the outputs to prevent damaging external circuits. The trip point of crowbar circuit is around 5.7V to 7V. The power supply will go into hiccup mode against shout circuit or over load conditions, and will auto-recovery while faulty conditions are removed |
|
Temperature: |
Operating: 0°~40°C
Storage: -40°~+75°C |
|
Connectors: |
AC Input: Meet IEC 320/CEE 22 standard
DC Output: Meet IEC 320 (reverse type)
CPU Board: Burndy GTC 6P-1 or equivalent
Disk Driver: AMP 1-480424-0 or equivalent
3.5" Floppy Drive: AMP 171822-4 or equivalent
AC Switch: Push switch (lever: 20mm) |
|
Dimensions: |
15.0 x 14.0 x 8.62 cm. Tolerance specified is +/-0.4mm between mounting holes and +/-0.8mm for other dimensions |
|
|
