|
|
 |
|
 Input Voltage: |
The range of input voltage is from 90~264VAC |
 |
Input Frequency: |
47~63Hz |
|
Input Current: |
The maximum input current is 0.65A at 115VAC or 0.32A at 230VAC |
|
Inrush Current: |
The cold inrush current will limit less than 50A at 264VAC input voltage |
|
Load Range: |
At factory, the output is checked between 4.9~5.1V (MPE-F40-05)/ 11.76~12.24V (MPE-F40-12)/23.5~24.5V (MPE-F40-24)/47.04~48.96V (MPE-F40-48) at 60% rated load |
|
Ripple and Noise: |
The peak to peak ripple and noise is less than 50mV (MPE-F40-05)/ 120mV (MPE-F40-12)/240mV (MPE-F40-24)/480mV (MPE-F40-48). Measuring is done by 20MHz bandwidth limited oscilloscope and terminated each output with a 0.1μF ceramic capacitor and a 10μF electrolysis capacitor at rated load, nominal line |
|
Line Regulation: |
The line regulation is less than +/-0.5% while measuring at rated load and from 100VAC to 240VAC input voltage changing |
|
Load Regulation: |
The load regulation for output is less than +/-1%, measuring is done by changing the output load +/-40% from 60% rated load |
|
Hold Up Time: |
Hold up time is 8mS typical at 115VAC input, full load |
|
Efficiency: |
The efficiency is 78% (MPE-F40-05)/84% (MPE-F40-12)/86% (MPE-F40-24)/88% (MPE-F40-48) typical while measuring is at nominal line and rated load |
|
Protection: |
The power supply will go into hiccup mode against short circuit or over load conditions, and will do auto-recovery while faulty conditions are removed |
|
Temperature: |
Operating: 0°~50°C
Storage: -40°~+85°C |
|
Humidity: |
5~95% non-condensing |
|
Connector: |
I/P Connector: Molex housing 09-50-3031 and Molex 2878 series crimp terminal
O/P Connector: Molex housing 09-50-3031 and Molex 2878 series crimp terminal |
|
Dimensions: |
10.16 x 5.08 x 3.05 cm; tolerance specified is +/-0.4mm |
|
|
