|
|
 |
|
 Input Voltage: |
90~130VAC or 180~260VAC, auto switchable |
 |
Input Frequency: |
47~63Hz |
|
Inrush Current: |
Not exceed 40A at 115VAC input or 80A at 230VAC input, at cold start 25°C |
|
Ripple And Noise: |
Peak to peak ripple and noise for each output is < 1% of each output voltage at rated load 115~230VAC |
|
Line Regulation: |
< +/-1% at rated load with +/-10% change in input voltage |
|
Load Regulation: |
The output voltage load regulation is less than the values on the table when each output loading changes +/-40% from 60% rated load while all other outputs at 60% rated load |
|
Hold Up Time: |
> 20ms at 115VAC input and rated load measured from the end of the last charging pulse to when the main output drops down to 95% output voltage |
|
Power Good: |
Goes high 100~500ms after all DC output are ready |
|
Power Fail: |
Goes low 0.5ms before any DC output falls |
|
Power On: |
TTL compatible signal (active low) used to switch ON the main output. When power on is disconnected from secondary common, all outputs except +5Vsb are turned off |
|
Efficiency: |
> 65% at nominal line and rated load |
|
Altitude: |
10,000 feet |
|
Protection |
Short Circuit: Hiccup mode function against short circuit or over load conditions auto restarts when fault conditions are removed
Output: Built-in crowbar circuit automatically shuts down outputs to avoid damaging external circuits. Trip point of O.V.P. circuit is between 5.7~7.0V |
|
Temperature: |
Operating: 0~70°C
Storage: -40~+75°C |
|
Humidity: |
Operating: 5~95%; non-condensing at 40°C |
|
Connectors: |
AC Input/Output: Meets IEC 320/CEE 22 standard
ATX Connector: Alex 9358-20 or equivalent device
3.5" Disk Drive: AMP 1-480424-0/171822-4 or equivalent device |
|
Dimensions: |
14.0 x 15.0 x 8.62 cm with +/-0.8mm and +/-0.4mm tolerance between mounting holes |
|
MTBF: |
119,695 hrs. |
|
|
