|
|
 |
|
 Input Voltage: |
90~132VAC or 180~260VAC selectable |
 |
Input Frequency: |
47~63Hz |
|
Input Current: |
10A at 115VAC or 6A at 230VAC max. |
|
Inrush Current: |
< 50A at 100VAC, < 100A at 220VAC, < 60A at 230VAC input cold start, 25°C excluding EMI capacitors |
|
Load Range: |
At 100% max. load condition in all outputs, +5V output is between 4.98V and 5.02V, +3.3V is between +3.25V and +3.35V. All other outputs are within their specified voltage accuracy ranges |
|
Ripple and Noise: |
Peak to peak ripple and noise for +5V and +3.3V outputs are < 60mV, and < 120mV for -5V, +12V, and +5Vsb outputs |
|
Line Regulation: |
< +/-1% for +5V, +12V, -12V, and +5Vsb outputs. +3.3V is +/-2% |
|
Hold Up Time: |
> 16ms at 115VAC or 230VAC input and max. laod measured from the last AC line charging pulse to the point when +5V drops down to +4.75V |
|
Output Power: |
Total DC continuous power is within 400W at < 30°C ambient temperature |
|
Power Good Signal: |
Signal goes high from 100~500ms after all output DC voltages are within regulation limits |
|
Power Redundancy: |
This power supply has power redundant capability |
|
Efficiency: |
65% typical, measured at nominal line and rated load |
|
Protection: |
Built-in over voltage protection circuit. Trip point between 5.7~7.0V AC line off and on cycle for over voltage protection recovery latch off mode against short circuit or over load conditions |
|
Dimensions: |
19.2 x 16.8 x 22.0 cm |
|
|
