-- SBC
-- Panel PC
-- Bare Bone System
-- Chassis
-- Power Supply
-- Backplane



MPI-706H-A
80W AC-DC Open Frame Power Supply



Large Image Download Center

 
 
Total Output Power:
maximum 80W with 8.6CFM forced air-cooling and 60W convection cooling at 50°C ambient temperature
Note:
1) The maximum total combined output power on the +3.3V and +5V rails is 40W
2) Measured by a 20MHz bandwidth limited oscilloscope and the each output is connected with a 10uF Electrolytic Capacitor and a 0.1uF Ceramic Capacitor
3) The +5V output is set between 5.08V to 5.13V by variable resistor and all output at 60% rated load and the other outputs are checked to be within the accuracy range
4) While input voltage below 100V (90-99V), an accessory heat sink or the chassis of application (min. 440 cm², aluminum with 1.5mm thickness) is recommend to be placed at the bottom of the power supply itself
Input Specification:
Power On/Off:
The powe supply will be turned on when the power On/Off pin is connected to secondary GND
Power Good Signal:
When power is turned on, the power good signal will go high 100ms to 500ms after all output DC voltages are within regulation limits
Power Fail Signal:
The power fail signal will go low at least 1mS before any of the output voltages fall below the regulation limits
Over Voltage Protection:
For some reason the power supply fails to control itself, the build-in over voltage protection circuit will protect auto-recovery model and to prevent damaging external circuits. The trigger point is about 6.5-8.5V at +5V
Over Load Protection:
Fully protected against output overload and short circuit. Automatic recovery upon of overload condition
Environment Specification:
Dimensions:
18.0 x 5.2 x 3.9 cm, Tolerance +/-0.4mm


Back


Copyright© BOSER Technology Co., Ltd. all rights reserved.
All specifications and photos are subject to change without notice.
All trademarks and brand names are the registered trademarks of their respective companies.